Cat.6A Pre terminated Copper Trunk Cable
Product advantage
- The six links of the pre terminated copper trunk are a combination, using the original high-performance Cat.6A shielded module and U/FTP cable with advanced stranding process, conform to ANSI/TIA 568.2-D Cat.6A, ISO/IEC 2nd class EA characteristic standard.
- The cable has four pairs of twisted wires, and each pair of wires is covered with aluminum foil Mylar tape, which effectively reduces the generation of crosstalk between pairs and external crosstalk; Transmission bandwidth reache 500MHz。
- The outer coating material of the cable is LSZH low smoke halogen-free type.
- Factory pre terminated, cable bundle management, and wrapped with high-density woven mesh, beautiful and tidy, and increased the wear resistance and compression resistance of the cable.
- One end (or both ends) of the pre terminated copper cable trunk is equipped with stay rings to facilitate and protect the trunk copper cable from routing between cabinets, reduce installation risks, and reduce the waste of installation site is reduced, and it can even be redeployed in the same place, which is more green and environmental friendly.
- The six links of the pre terminated copper trunk have passed 100% of the original factory test, with full certification and performance guarantee.
- There are obvious serial number marks on the cables, which are arranged in order and plug and play on site.
- Faster "field operation" time, about 8 times faster than conventional cabling.
- Comply with ROHS 2011/65/EU environmental protection standards.
Product characteristics
Non plenum fire rating: LSZH
Conductor wire gauge: ψ 0.565mm (23AWG) Insulation material: Foam PE, 1.38 ± 0.05mm
Twisting mode: 4 pairs of cables, 2-core pairs
Shielding layer: aluminum foil Mylar tape for each pair Skin material: LSOH
Cable outer diameter: 6.9 + / - 0.3mm
Rated transmission speed (NVP):78%
Plugging times: >750
Tension: >100 grams
Insulation resistance: 500MΩ HM minimum @100VDC
Gold needle contact resistance: 20MΩHM max
IDC contact resistance: 2.5MΩHM max
Withstand voltage: 1000 VAC RMS @60hz/1min
Rated current: <1.5Amps
Working temperature: -20 ℃ to +75 ℃
Meet the standards
ANSI/TIA 568.2-D Category 6A
ISO/IEC 11801(IEC 61156-5)Category 6A
EN55022 Class B IEC 60332-1-2
IEC 60754-2、IEC 61034-1、IEC 61034-2
Can be used
10/100Base-TX
1000Base-T
2.5G/5GBase-T
10G Base-T(10Gigabit Ethernet)
1.2/2.4 Gbps ATM
TP-PMD(ANSI X3T9.5 100Mbps)
4/16Mbps Token Ring ISDN
PoE++
Order information
Transmission performance
P4.02.02_Cat6A Pre terminated Copper Trunk Cable.pdf
Recommend
-
-
QQ Zone
-
Sina Weibo
-
Renren.com
-
Douban